Zone Bypassed Memory; Zone Tamper Memory; User Codes - Inhep Digital Security IDS 805 User Manual

5. The alarm memory will be erased the next time the system is armed.
10.2
The Zone Bypassed Memory displays any zones which were bypassed during the most recent arming
cycle.
To Display Zone Bypassed Memory:
1. Hold down [0] until the keypad buzzer sounds.
2. The READY indicator will turn off and the keypad buzzer will sound briefly.
3. Flashing zone indicators show which zones were violated during the last armed cycle.
4. To view any bypassed zones, press the [1] key once.
5. Zones that have been bypassed will have flashing indicators.
6. The memory status will be displayed for five seconds.
10.3
The Zone Tamper Memory displays any zones where a tamper condition has occurred.
To Display Zone Tamper Memory:
1. Hold down [0] until the keypad buzzer sounds.
2. The READY indicator will turn off and the keypad buzzer will sound briefly.
3. Flashing zone indicators show which zones were violated during the last armed cycle.
4. To view any tampered zones, press the [2] key once.
5. Zones that have registered a tamper condition will have flashing indicators.
6. The memory status will be displayed for five seconds.
11.
The IDS805 Alarm Panel has 15 programmable user codes.
Code 1: Master User Code
Code 2 – 13: General User Codes
Code 14: Maid's Code
Code 15: Duress Code
11.1
[*] + [MASTER USER CODE] + [*] + [CODE NUMBER] + [*] + [NEW CODE] + [*]
1. Hold down the [*] key until the keypad buzzer sounds.
2. The ARMED and READY indicators will flash alternately, indicating that the system is in the mode
which allows programming of user codes.
3. Enter the [MASTER USER CODE] (the factory default is 1234) followed by the [*] key.
17

Zone Bypassed Memory

Zone Tamper Memory

Entering New and Changing Existing User Codes
IDS 805 User Manual 700-266-01C Issued March 2009
[0] then [1]
[0] then [2]

User Codes