Zone Information; Arming The System; Away Arming; Quick Away Arming - Inhep Digital Security IDS 805 User Manual

4.3
Zone Zone Type e.g. Entry/Exit
1
2
3
4
5
6
7
8
The Primary Entry Delay is
The Secondary Entry Delay is
The Exit Delay Is
5.
There are various options for arming the system
5.1
1. Ensure that the READY indicator is on; if not, check that all protected doors and windows are
closed and that motion has ceased in areas covered by motion detectors.
2. If necessary, close the front door.
3. Press the [#] key to cancel any unintended key entries.
4. Enter a valid 4 digit [USER CODE]. If you make a mistake, press the [#] key and re-enter the
code.
5. The ARMED indicator will come on and the keypad's buzzer will sound on and off for the duration
of the exit delay. A steadily lit zone indicator will show any bypassed zones.
6. The arming process has begun. Leave only via the Follower and Entry/Exit zones.
7. The panel will arm at the end of the exit delay.
OR
If the panel is so programmed, violating the Push to Arm zone will arm the panel immediately.
5.2
If this function is enabled, it is possible to AWAY arm by simply holding down the [1] key until the keypad
buzzer sounds and the arming process begins.
11

Zone Information

Arming the System

Away Arming

[#] + [USER CODE]
(Leave via Entry/Exit Zone)

Quick Away Arming

Hold down the [1] key until the beep
IDS 805 User Manual 700-266-01C Issued March 2009
Zone Name e.g. Kitchen Door
Seconds
Seconds
Seconds