Toyotomi CFT 35 INV-Ri Service Manual page 77

TLC-I-2011.1
2. Transmitting display: The icon will flash once when the signal is sent by remote controller.
3. ON/FF: Icon is displayed when the remote controller is turned on, or vice versa.
4. Running mode: Press MODE to display current running mode. AUTO, COOL, DRY, HEAT and FAN can
be selected. (HEAT function is invalid for cool only type unit.)
5. Time: Display the current set time. Press CLOCK for 5s, icon indicating hour will flash. Press this button
again, icon indicating minute will flash. And are used to adjust the figure . Setting or modification is
effective only by pressing OK button to make confirmation.
6. Lock: The icon will be lightened or off when pressing LOCK. In locked state, all the buttons are
ineffective except button LOCK.
7. Time ON/OFF: In the state of time ON, icon ON will be lightened, which is the same to the state of time
OFF. Setting timer ON and OFF simultaneously, both icons ON and OFF are displayed.
8. Fan speed: Press FAN SPEED to display the current wind speed. AUTO, LOW, MED and HIGH can be
selected. The default state is high fan speed for the unit without medium fan speed.
9. Economic operation: This icon will be lightened or off when pressing ECO button.
NOTE: All the above icons will be displayed only when the remote controller is electrified for the first time or
reset.
OPERATION INSTRUCTIONS
Install and replace batteries
Install 2 pieces of 7# alkaline batteries.
Slide the cover to install batteries and make sure to place them in right pole.
AUTO operation
Switch on the power and running indicator light on indoor unit flashes.
1. Press MODE to select AUTO.
2. Adjust temp via and. Generally the range is 17° C ~30° C.
3. Press ON/OFF and running indicator light on indoor unit is lightened. Air conditioner will work on AUTO
mode and fan speed is AUTO which is nonadjustable.
4. ECO is effective on AUTO operation.
COOL/HEAT/FAN operation
1. Press MODE to select COOL, HEAT or FAN.
2. Adjust temp via and. Generally the range is 17° C ~30° C.
3. Press FAN SPEED to select AUTO, LOW, MED or HIGH.
4. Press ON/OFF and running indicator light on indoor unit is lightened. Air conditioner will work on the set
mode. Stop operation via ON/OFF.
To adjust the figure. Setting or modification is effective only by pressing OK button to make confirmation.
NOTE: On FAN mode, temp is nonadjustable and ECO is ineffective. Procedure 2 is omitted.
DRY operation
1. Press MODE to select DRY.
2. Adjust temp via and. Generally the range is 17° C ~30° C.
3. Press ON/OFF and running indicator light on indoor unit is lightened. Air conditioner will work on DRY
mode. Turn off the unit via ON/OFF.
4. On DRY mode, ECO and FAN SPEED are unavailable.
Timer operation
TIME ON and TIME OFF are used to turn on and turn off the unit at the set time respectively.
TIME ON operation
1. Press TIME ON, icon SET, HOUR and ON are lightened.
2. Press TIME ON again and adjust the time.
3. Keep pressing this button, the time will increase by 0.5 hour. When the set time exceeds 10 hours,
pressing the button will increase the time by 1 hour.
4. 0.5s after setting, remote controller will send TIME ON command to the unit.
235