Other Parameters - Roland SH-201 Owner's Manual

Parameter list

Other parameters

You cannot edit these parameters by using SH-201 Editor.
Parameter Value
DEVICE ID 17–24
RECORDER OFF, ON
SYNC OUTPUT
RECORDER OFF,
METRONOME REC-ONLY,
MODE REC&PLAY,
ALWAYS
RECORDER 0–7
METRONOME
LEVEL
70
Explanation
When you want to transmit or receive System Exclu-
sive messages, set this parameter to match the Device
ID number of the other MIDI device.
If this is "ON," MIDI Clock messages will be trans-
mitted to an external MIDI device.
Specifies when you want the metronome to sound.
OFF: Metronome will not sound.
REC-ONLY: Metronome will sound only for re-
cording.
REC&PLAY: Metronome will sound for record-
ing and playback.
ALWAYS: Metronome will always sound.
Specifies the volume of the metronome.
Panel operation
1. Hold down the CANCEL button and press the
TAP button
2. Press the PRESET button
3. Hold down the WIDE button and press a
NUMBER button (1–8)
1: 17, 2: 18, 3: 19, 4: 20, 5: 21, 6: 22, 7: 23, 8: 24
4. Press the CANCEL button
1. Hold down the CANCEL button and press the
TAP button
2. Press the PRESET button
3. Press the PLAY/STOP button
PLAY/STOP indicator is lit: ON
PLAY/STOP indicator is dark: OFF
4. Press the CANCEL button
1. Hold down the CANCEL button and press the
TAP button
2. Press the PRESET button
3. Hold down the REC button and press a BANK
button (A–D)
A: OFF
B: REC-ONLY
C: REC&PLAY
D: ALWAYS
4. Press the CANCEL button
1. Hold down the CANCEL button and press the
TAP button
2. Press the PRESET button
3. Hold down the REC button and press a NUM-
BER button (1–8)
1–8: 0 (minimum)–7 (maximum)
4. Press the CANCEL button