How To Edit - Roland SPD-20 Owner's Manual

How to Edit

To modify parameter values you must be in the Edit mode. The names of all the parameters you can
modify are in the Parameter List printed on the front panel.
MEMO
"Edit" refers to the process of changing parameter values.
How to read the parameter list
The parameter list has four indicators arranged horizontally and seven indicators arranged vertically. In
the Edit mode, one of the horizontal indicators and one of the vertical indicators will always be lit. This
shows which parameter is being edited; i.e., the intersection of the indicated column and row is the cur-
rently selected parameter. The display shows the value of this parameter. To edit a particular parame-
ter, refer to the parameter list and use the [SELECT] and [
fig.18
Selected Parameter
Value (flashing)
MEMO
Use PATCH/VALUE [-] or [+] to modify the parameter value.
20
The intersection of the
indicated column and row
INST
LEVEL
PITCH
DECAY
PAN
CURVE
FX SEND
can be set
to each pad
] [ ] buttons to select it.
TX CH FX TYPE
NOTE # FX TIME
GT TIME FX LEVEL
PAN PDL CTRL
CURVE PDL LEVEL
SENS PDL CC #
PGM CHG
can be set to
each Patch
BASIC CH
BULK DUMP
PATCH EXPAND
TRIG SENS
TRIG THRESHOLD
TRIG TYPE
TRIG CURVE
can be set to
the entire system