Advertisement
Using the UDM-RC05 for Video Compensation
The UDM-RC05 can also be used with UDM-RX02N receivers for video
compensation (FIG. 2):
Blue skew increase
Green skew increase
Red skew increase
Sharpness
FIG. 2
UDM-RC05 IR Remote Control - Video Compensation buttons
Note: In order to use the UDM-RC05 to compensate video on the UDM-RX02N,
the RX02N must be set to the AMX remote, via the "RP" command (see below).
•
Enter setup mode - press MENU, then AMX
•
Exit setup mode - EXIT
•
Red skew increase - RED
•
Green skew increase - GREEN
•
Blue skew increase - BLUE
•
Gain (brightness) - LEFT and RIGHT
•
Sharpness - UP and DOWN
"RP" SEND_COMMAND
•
Device SEND_COMMANDS are sent to Port 1 on the UDM-RX02N.
•
All text is based on a Unicode index.
"RP" SEND COMMANDs (UDM-RX02N)
"'RP<P#>'"
The Rx can support a number of different remotes which
are mapped through to button pushes
Sets the protocol
used by the IR remote.
Syntax:
SEND_COMMAND <DEV>, "'RP<P#>'"
Variables:
• P#:
"ENDELEO", "AMX", "SKY", "TIVO", "DIRECTV",
"MIOR1", "MIO", "RC02", "RC05"
Example:
SEND_COMMAND dvRX, "'RPRC05'"
Configures the Rx to use an AMX remote.
The available remotes are:
• ENDELEO, RC02 - grey 33 button or 13 button remotes
• AMX, RC05 - beige 43 button
• SKY - Sky satellite remote
• TIVO - standard Tivo remote
• DIRECTV - standard DirecTV remote
• MIOR1 - AMX R1 remote
In all the above cases, the push and release codes are
endeleo codes.
MIO - AMX R1 remote - this setting uses all 255 push/
release codes.
"'?RP'"
The Rx can support a number of different remotes which
are mapped through to button pushes.
Returns the protocol
used by the IR remote.
Syntax:
SEND_COMMAND <DEV>, "'?RP'"
Example:
SEND_COMMAND dvRX, "'?RP'"
The port would respond with RP-ENDELEO.
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
©2010 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
Press MENU then AMX
to enter Setup mode
Press EXIT to exit Setup mode
Gain (Brightness)
4/10
AMX reserves the right to alter specifications without notice at any time.
Additional Documentation
For detailed programming information as well as installation and configuration
instructions for the UDM-0808-SIG and UDM-RX02N, refer to the
UDM-0808-SIG, UDM-RX02N & UDM-ABB-8-SIG Operation/Reference Guide
(available at www.amx.com).
93-1402-70
REV: B
Advertisement
