(A) Unpacking The Sdproc Command Module; Inspect Package For External Damage; Unpack The Command Module; Returning Merchandise For Repair - Aalborg Command Module Operating Manual

(a) UNPACKING THE SDPROC COMMAND MODULE

a.1 Inspect Package for External Damage
Your SDPROC Command Module was carefully packed in a sturdy cardboard carton,
with anti static cushioning materials to withstand shipping shock. Upon receipt,
inspect the package for possible external damage. In case of external damage to the
package contact the shipping company immediately.
a.2 Unpack the Command Module
Open the carton carefully from the top and inspect for any sign of concealed shipping
damage. In addition to contacting the shipping carrier please forward a copy of any
damage report to your distributor or Aalborg7 directly.
When unpacking the instrument please make sure that you have all the items indicat-
ed on the Packing List. Please report any shortages promptly.
a.3 Returning Merchandise for Repair
Please contact the customer service representative of your distributor or Aalborg7 if
you purchased the equipment directly, and request a Return Authorization Number
(RAN). Equipment returned without an RAN will not be accepted. Aalborg7 reserves
the right to charge a fee to the customer for equipment returned under warranty claims
if the instruments are tested to be free from warranted defects.
Shipping charges are borne by the customer. Equipment returned "collect" will not be
accepted!
It is mandatory that any equipment returned for servicing be purged and neutralized of
any dangerous contents including but not limited to toxic, bacterially contagious, cor-
rosive or radioactive substances. No work shall be performed on a returned product
unless the customer submits a fully executed, signed SAFETY CERTIFICATE. Please
request form from the Service Manager.

(b) INSTALLATION

See AFM/AFC/GFM/GFC/DFC manual for specific instructions on the use and operation
of the mass flow meter or mass flow controller transducers.
b.1 Location of Installation
Set the SDPROC in a location where it will be used. This should be a stable surface.
Avoid exposing the SDPROC to damaging heat radiation from sunlight or heaters.
Avoid vibration and protect the product from moisture or aggressive chemical vapors.
1