Setup Totalizer Mode Display; Setup Totalizer Start Flow Display; Setup Totalizer Stop Volume Display; Setup Totalizer Action Display - Aalborg Command Module Operating Manual

e.2.8.1 Setup Totalizer Mode Display
To change Totalizer Mode in ENABLED or DISABLED, press the button (UP, DOWN
respectively) directly below the mode shown on the display. To return to the Main
Display, press the ENTER button under EXIT on the display. Press the ESC button
under NEXT on the display to go to the Totalizer Start settings. The following Setup
Totalizer Start Flow Display will appear.
e.2.8.2 Setup Totalizer Start Flow Display
Pressing (+) or (-) will increment or decrement Totalizer Start settings per 0.1% F.S.
respectively. If no settings are required for Totalizer Stop value press the ENTER but-
ton under EXIT on the display, to go back to the Main Display. Press ESC button under
NEXT on the display to go to the Totalizer Stop settings. The following Setup Totalizer
Stop Volume Display will appear.
e.2.8.3 Setup Totalizer Stop Volume Display
The proper settings of the Totalizer Stop Volume (in volume/mass based engineering
units) is required if the Totalizer is set to Enabled. The engineering unit for Totalizer Stop
Volume has to be related to the current active engineering unit. If for example current
engineering unit is sLPM, the Totalizer Stop Volume has to be entered in liters. Press the
ENTER button under (--->) on the display, to move the flashing cursor to the digit, which
has to be adjusted. Pressing (+) or (-) will increment or decrement the particular digit
respectively. The numbers will change from 0 to 9 and next to the decimal point (.).
Pressing the (+) button one more time will change the highlighted position of the cursor
back to 0. The same is true in reverse direction when pressing the (-) button. Only one
decimal point is allowed. If changing the position of the decimal point is required, change
decimal point to any desired digit, then move the cursor to the required position, and
adjust it to the decimal point with (+) or (-) button. When complete with Totalizer Stop
Volume settings, press the ESC button under NEXT on the display, to go to the Totalizer
Action screen. The following Setup Totalizer Action Display will appear.
e.2.8.4 Setup Totalizer Action Display
13