Deployment Task
Configure firmware settings for auto-registration.
Configure global SV-4K settings.
Power on the SV-4K device.
Verify the startup sequence.
Prerequisites for SV-4K Deployment
Before you deploy SV-4K media players, be sure that the following requirements are
met:
The pre-deployment tasks are completed. For more information, see
l
SV-4K Media Player Deployment" on
The SV-4K hardware is not yet powered up.
l
Provisioning the SV-4K Firmware
Each time the SV-4K device powers on or reboots, a compliance check is done against
the firmware that is loaded on the device against the Cisco StadiumVision Director
auto-registration settings. If the firmware versions do not match, the SV-4K initiates a
firmware upgrade automatically.
Before the SV-4K device can update the firmware, the firmware must be uploaded to
Cisco StadiumVision Director and the auto-registration settings must be configured.
28 of 68
For more information see:
"Configuring the SV-4K for Auto-
Registration" on page 31
"Configuring the SV-4K Global Settings" on
page 32
"Verifying the SV-4K Startup Sequence" on
page 41
page 19.
© Cisco Systems, Inc. All rights reserved.
—
"Planning the