Omron NA5-12W series Hardware User Manual page 58

2 Configuration Units
Connecting with Ethernet
You can use a direct connection or connect through an Ethernet switch by connecting to Ethernet port 2
on the NA Unit.
Sysmac Studio
Ethernet cable (direct
connection or connection
through an Ethernet switch)
• Connect the Sysmac Studio to Ethernet port 2.
• The IP address and connection device do not need to be specified at the Sysmac Studio. Select the
Direct Connection with Sysmac Studio Check Box under HMI Settings − TCP/IP Settings and then
connect to Ethernet port 2.
• You can make the connection either with or without a switching hub.
• The Ethernet port on the NA Unit supports Auto-MDI, so you can use either a cross cable or a
straight cable if you connect directly to the computer.
Refer to the NA-series Programmable Terminal Device Connection User's Manual (Cat. No. V119) for
information on recommended Ethernet switches and connection details.
2 - 14
Back Panel of
NA Unit
Connect to Ethernet port 2 (on the right).
Ethernet port 2
Ethernet port 1
NA-series Programmable Terminal Hardware User's Manual (V117)
Back Panel of
NA Unit