The Basement Watchdog big dog + Instruction Manual & Safety Warnings

The Basement Watchdog big dog + Instruction Manual & Safety Warnings

A/c-d/c battery backup sump pump system

Advertisement

This manual is for the systems that have
the BWD12-120C-A backup controller,
which can accommodate maintenance or
maintenance free batteries. See pages 2
and 8 for additional information.
A/C-D/C
Battery Backup
Sump Pump
System
PUSH
PUSH
to T
to Test
est
or Reset
or Reset
Instruction Manual
& Safety Warnings

Table of Contents

Instructions
1
1
1
Items included in system
2
2
2
2
Installation options
3
4
5
6
7
8
Positioning the float switch
9
10
10
10
10
Lights and Alarms
11
IMPORTANT: Even if you have the Basement Watchdog backup sump
pump system installed by someone else, you must read and follow
the safety information contained in this manual. Failure to do so
could result in property damage, serious injury, or death.
11
12
12
13
14
14
14,15
15
15
15
15
15
15
Testing the System
16
16
16
16
16
16
Technical support
16
17
18
19

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the big dog + and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for The Basement Watchdog big dog +

  • Page 1: Table Of Contents

    Silencing the alarm Warranty This manual is for the systems that have IMPORTANT: Even if you have the Basement Watchdog backup sump the BWD12-120C-A backup controller, pump system installed by someone else, you must read and follow which can accommodate maintenance or the safety information contained in this manual.
  • Page 2: Important Safety Warnings And

    • DO NOT walk on wet areas of the basement any repairs at the following address: • When connecting the battery cables, first • Use the Basement Watchdog control unit for until all power has been turned off. If the Glentronics, Inc.
  • Page 3: Introduction

    • Two (2) acid packs to fill the dry batteries The Basement Watchdog Big Dog backup sump The use of a Basement Watchdog battery is • A set of battery cables with rings on both...
  • Page 4: Pump & Pipe

    NARROW SUMP PIT INSTALLATIONS If the direct discharge method is not possible or FLOOR convenient, the Basement Watchdog pump can FLOOR JOIST SLOPE JOIST SLOPE...
  • Page 5: Direct Discharge To Outside

    1/8” hole must be drilled in DIRECT DISCHARGE TO THE OUTSIDE OF 4. Attach a union or a check valve to the top of the PVC pipe above the Basement Watchdog THE BUILDING (Diagram A) the 1½” pipe. This will allow the pump to be pump.
  • Page 6: Connection To Existing Discharge

    2. Install a check valve on the top of the PVC and cement the top of the “Y” assembly to the 1-1/2" pipe attached to the Basement Watchdog discharge pipe with the “Y” extension facing PVC PIPE pump. Make sure it is installed with the arrow down toward the backup pump.
  • Page 7: Direct Discharge For Narrow Sumps

    1/8” hole must be drilled in the PVC pipe Installation Instructions above the Basement Watchdog pump. Drill the 3. Secure the pump wire so that the plug on the hole at a 45° angle toward the bottom of the end will not fall into the sump.
  • Page 8: Connection To Existing Discharge

    If a 1/8” hole attached, simply press the rest of the pump check valve of the Basement Watchdog pump, correct lengths. It is important to keep the is not drilled above the pump, an air lock onto the mounted strainer.
  • Page 9: Battery Instructions

    The Basement Watchdog Big Standby battery has The Basement Watchdog Standby batteries are off each cell equally. It is important to have...
  • Page 10: Control Unit Connections

    When you fill the battery for the FIRST time, (+) post of the battery or the alarm will sound OVERFILL THE BATTERY. (Diagram E) continuously. The Basement Watchdog sump it will be the ONLY time you add acid to the A newly filled battery will sometimes require pump system will NOT warn you if the fluid level battery.
  • Page 11: Connecting The Pump

    the top of the cap. Do not glue the sensor into not warn you if the fluid level is low in this the cap. (b) If the top of the battery has two configuration. You will need to check your large caps, place the fluid sensor in the hole battery every couple of months to see if it molded on the top of the battery.
  • Page 12: Understanding The Warning

    Warning Light Alarm corrected is corrected on page 8. (The Basement Watchdog battery filler will automatically fill the level to the Understanding the Battery fluid low correct height. See enclosed order form.) Battery problem No, push BLUE button Warnings &...
  • Page 13: Battery Problem

    corrected, the battery should recharge. internal safety feature will not allow the charging system to activate. Call the Glentronics • If no other lights are on, this means the service department for instructions or replace terminals may be corroded, and the battery the battery.
  • Page 14: Replacing The Battery

    REPLACING THE BATTERY 3. Fan the area around the top of the battery with a piece of cardboard (or another non- DANGER metallic material) to remove any hydrogen or oxygen gas that may have been emitted from Risk of electrical shock or battery explosion, REMOVE the battery.
  • Page 15: Power Failure

    REFER TO THE PHOTOS AT RIGHT amp glass barrel fuse, commonly found at hardware stores and auto supply stores. Plug The Basement Watchdog control unit will check in the control unit. (You should provide the pump and its wire connections each week for additional protection for the control unit by possible pump failure.
  • Page 16: Pump Was Activated

    Review the safety instructions on page 1. REFER TO PHOTOS AT LEFT AND ABOVE 1. Unplug the Basement Watchdog control unit from the wall outlet. 2. Remove the cover of the battery box by 3.
  • Page 17: Testing The Float Switch

    Basement Watchdog Connect Modules. THE REMOTE TERMINAL Model No. BW-HZM The Basement Watchdog Big Dog backup sump pump can be connected to a home security system or other alarm devices to alert you to a power, or simply by aging, the gauge will problem or required maintenance.
  • Page 18: Troubleshooting Guide

    Troubleshooting Guide DANGER Read safety warnings & instructions before attempting any repairs or maintenance. Potential Cause BATTERY FLUID LOW Solutions The battery fluid is low ......Add distilled water to each cell of the battery The fluid sensor is installed improperly .
  • Page 19: Other Products

    If you’ve spent any time in your basement, You can detect leaks before they become bigger The Basement Watchdog line of AC sump pumps It’s probably the result of a float switch that is you’ve probably noticed your sump pump turning...
  • Page 20: Limited Warranty

    Limited Warranty By opening this package and using this GLENTRONICS, INC. product, you are agreeing to be bound by the terms of the GLENTRONICS, INC. limited warranty (“warranty”) as set out below. Do not use your product until you have read the terms of the warranty. If you do not agree to the terms of the warranty, do not use the product and return it within the return period stated on your purchase receipt from the retail store or authorized distributor where you purchased it for a refund.

This manual is also suitable for:

Emergency

Table of Contents