Diagram L - Combined Connections Third Party Lock - Bell System 2-72 Multi Way Installation And Operating Manual

tabellet Apartment Station 2-72 Way System
Diagram L – Combined Connections Third Party Lock
Connecting a Bell PAX1 Proximity Reader
Lock
free
bell
Door
Controller
Supply
free
The bell door controller is set to fail secure. The diagram assumes a common
power supply, if not an extra wire will be required to connect the PAX1 Exit O to the
free
bell 12V-.
N.B. The power wiring to the PAX1 must be able to carry the lock current with less
than 2V voltage drop.
ACT 1000/2000/3000 Proximity Controller or 100e/200e Extender
free
Lock
bell
Door
Controller
Exit
Notes
1. Connect the lock release or Maglock using the ACT Manuals.
free
2. Leave the bell
3. A normally open exit button can still be fitted to the ACT controller in addition to the
free
bell wiring.
4. If the 2 units are not sharing a power supply, then a connection from bell
Exit- to ACT 0V will be required.
5. Look for the notes on the ACT installation diagram concerning the use of links when
the door contact is not used and when a power supply without power fail is not used.
PD-307 Issue 2
+
–
Exit button Exit button
(Optional) (Optional)
–
+
–
–
controller set to Fail Secure regardless of the type of release used.
Installation and Operating Manual
PAX1
Z
Exit Z
Proximity
O
Exit O
Reader
IP3 Push button
IP2 Door contact
IP1 Aux input
0V
OP2 ACT
OP3
free
controller
Page 45 of 48