Denso BHT-1400QWB-CE Software User Manual page 59

 Changing the FTP Client Configuration
Error messages during FTP download or upload.
Message
Connection error XXXX
Server IP or Name required Either the server IP or host name is
User ID required
Cannot contain any of the
following characters.
The path is invalid.
The path is too long.
Filename required
The file is read only.
The file could not be found.
This file already exists.
Replace existing file?
To change the FTP Client Configuration, tap the Config... button.
The FTP Client Configuration is displayed.
Change the settings as explained in the FTP Client Configuration section.
Problem
Failed to connect to the server.
not specified.
Either the user ID or password is
not specified.
The folder or file name is not
correct (e.g., unsupported or very
long characters are used)
The file name is not entered.
No data can be written to the file
that is selected as the download
destination.
The selected file cannot be found.
The same file already exists.
- 51 -
Solution
Check the network environments,
server active status and FTP settings.
Specify the server IP or host name.
Either the user ID or password is not
specified. Specify the user ID or
password.
Specify the correct folder or file name.
Enter the file name.
Change the read-only file to the
read-write file, or select another file.
Select an existing file name.
Select Yes to overwrite the file.
Select No not to overwrite the file,
then select another file and retry.