Proper Use - Wieland gesis LON R-56/0 (RC) Manual

This operating manual uses various safety notices that are assigned according to the sever-
ity of a potential hazard:
"Danger" indicates an imminently hazardous situation or state which, if not avoided, will
result in serious injuries or death. The use of "Danger" is limited to the most extreme situa-
tions.
"Warning" indicates a potentially hazardous situation or state which, if not avoided, canre-
sult in serious injuries or death.
"Caution" indicates a potentially hazardous situation or state which, if not avoided, can
result in minor or moderate injuries. "Caution" is also used to warn against unsafe prac-
tices or obvious misuse, as well as for situations which may result in material damage or
personal injury.
"Danger" or "Warning" are basically used for cases which present a risk to life or limb.
Damage to property only falls into these categories if there is also a risk of personal injury
that corresponds to these levels.
1.3

Proper Use

• Electrical installations, commissioning and maintenance work, as well as configuring and
programming work, must only be performed by qualified electricians with relevant acci-
dent prevention training, and in compliance with the applicable regulations.
• Safety precautions and safety devices must comply with the applicable regulations.
• Compliance with the required regulations is achieved when the devices are correctly
processed in order to create an end product.
• Damaged products must neither be installed nor put into operation.
• On account of the class and degree of protection, all devices must be installed in a gesis
distribution box (gesis RAN) or similar housing.
• Due to their holding equipment, devices without locking feet may only be installed in a
gesis RAN housing provided by Wieland Electric.
• A power supply from the gesis RM series of devices is required for operating the basic
module. If a power supply other than the gesis product intended for this purpose is used,
Wieland Electric GmbH cannot guarantee that faultless operation will take place.
•
When looping through the voltages, the maximum current of 16 A must not be ex-
ceeded.
The control system must only be used when in proper working condition, as well as ac-
cording to its prescribed usage, with due regard given to safety, awareness of any hazards
and following the instructions contained in the operating manual. Reliable and safe opera-
tion requires proper transport, storage and installation, as well as careful operation. In
particular, safety-related faults must be rectified immediately by a professional.
The control systems are exclusively intended for controlling building equipment. Other
applications, or use beyond this scope, are considered to be improper. The manufacturer
assumes no responsibility for any damage resulting from usage of this nature.
In order to use the control systems as prescribed, the instructions outlined in this oper-
ating manual must be followed for mechanical and electrical installation procedures, as
well as for commissioning and operation of the systems.
Wieland Electric | BA000580 | 6/2009 (Rev. A)
About This Operating Manual
DANGER
WARNING
CAUTION
WARNING
NOTICE
7