Table of Contents
Advertisement
Parameterisation
The 1-byte sensor measures physical data. You must specify the type of the measured
value here. Depending on this, you can select the measuring range in the second window.
The following physical factors can be parameterised:
• Temperature value
• Brightness value
• Humidity value
• Pressure value
• CO
Thereby, the network variable type is automatically adjusted to the parameterised physical
factor. For this reason, the parameterisation is only possible for not connected network
variables.
area of the window.
7.5.3.1
1-byte sensor
temperature value
(Tab 1)
When a temperature sensor is used, the measuring range of the sensor can be specified
on the second screen (Tab 1). A negative value is input by setting the "leading sign" check
mark. The counting direction can also be adjusted for the sensor used.
32
SNVT_temp_p
SNVT_lux
SNVT_lev_percent
SNVT_press
concentration
SNVT_ppm
2
The transmit behaviour of the network variables can be parameterised in the bottom
1-byte sensor (temperature value)
Wieland Electric | BA000580 | 6/2009 (Rev. A)
Advertisement
Table of Contents
