Learning New Functions On Device Buttons - Arcam CR 9000 Operating Manual

Using Your Remote
Repeat Steps 4 through 7 for any other buttons you wish to learn new functions.
8 Once you have completed the learning for all the desired buttons in a Device
mode, store the learned functions by pressing the Device and SEL/PLAY
buttons simultaneously, once again. The LCD in the CR9000 will show
SAVED and then return to the Device Mode. The remote has now returned
to the original operating mode.
Once you have stored the learned functions, test the buttons that have been taught.
If any of the buttons do not operate as they should, please repeat from Step 1 for
those buttons.
Note: If the LCD shows FAIL at any time during the learning process,
the CR9000 was unable to learn the new functions. Please repeat
from Step 4. If the CR9000 continues to show FAIL during the
learning process, please try the following suggestions:
‚
Increase or decrease the head to head distance between the two remote
controls, within a 1 to 5 inch range.
‚
Increase or decrease the time you press and hold the button on the
original remote control in step 5, for 1 to 2 seconds.
‚
Avoid fluorescent lights or strong sunlight during the set up. These
lighting conditions can cause interference with the learning process.
‚
Verify that the original remote control contains fresh batteries.
Some remote controls operate at non-standard IR, UHF or ultrasonic frequencies,
and are unable to be learned. If you continue to experience difficulty during set up,
please contact our customer support department for assistance.
15
Using Your Remote

Learning New Functions on Device Buttons

The eight Device buttons at the top of the remote control can also learn new
functions. These buttons can only be set up in the Audio mode. If a new function is
learned on a Device button, the new function will override any existing
preprogrammed information on the Device button.
1 Place the CR9000 and the original remote control to be learned from, on a
flat surface. Line up the remote controls head to head, about 2 to 3 inches
apart.
2 Press and hold both the Audio and SEL/PLAY buttons simultaneously, for
about three seconds, until the LCD on the CR9000 shows LEARN. The
CR9000 is now in the learning mode.
Note: Each of the following steps must be completed within 20
seconds. If the remote does not receive any commands within the
allotted time, it will return to its normal operating mode.
3 Press and release one of the eight Device buttons on the CR9000. The LCD
will show READY.
4 Press and hold the button on the original remote control you wish to teach
into the CR9000, for about 3 seconds. The LCD on the CR9000 will show
— — — — indicating that it is receiving the information from the original
remote control.
5 Release the button on the original remote control. The LCD on the CR9000
will show RETRY.
6 Press and hold the same button on the original remote again, for about 3
seconds. The LCD on the CR9000 will flash GOOD, the Device Mode and
then return to LEARN, verifying that the new function has been learned.
16