Learning Set Up; Learning New Functions On The Main Keypad - Arcam CR 9000 Operating Manual

Using Your Remote
C: Learning Set Up
The Arcam CR9000 has the ability to learn new functions from your original
remote controls:
• There are 8 "pages" of learning with each page corresponding to the 8
Device modes on the remote control: AUDIO, CD, DVD, AUX, SAT, TV,
VCR, CBL.
• All buttons in all Device modes can learn, except the LIGHT button.
• The 8 Device buttons at the top of the remote control labelled (AUD, CD,
DVD, SAT, TV, VCR and CBL) learn only in the Audio mode.
• Learned functions override any existing preprogrammed functions on the
remote control.
• Learned functions are automatically erased when a new function is
learned on the same button.
• Learned functions are retained even after a different three digit code
number is programmed into the remote control.
• To erase a learned function and return to an original preprogrammed
function, please refer to the section Erasing Learned Functions (page 17).

Learning New Functions on the Main Keypad

1 Select the mode in which you wish to learn the new function by pressing the
corresponding Device button.
2 Place the CR9000 and the original remote control to be learned from, on a
flat surface. Line up the remote controls head to head, about 2 to 3 inches
apart.
5 to 7.05 cm
13
Using Your Remote
3 Press and hold both the Device button selected in Step 1 and the SEL/PLAY
button for about three seconds, until the LCD on the CR9000 shows
LEARN. The CR9000 is now in the learning mode.
N o t e :
of the following steps must be completed within 20 seconds. If the
remote does not receive any new commands within the allotted time, it
will return to its normal operating mode.
4 Press and release a button on the CR9000 you have selected to learn the new
function. The LCD will show READY.
5 Press and hold the button on the original remote control for about 3 seconds
from which you are learning the new function. The LCD on the CR9000
will show _ _ _ _ indicating that it is receiving the information from the
original remote control.
6 Release the button on the original remote control. The LCD on the CR9000
will show RETRY.
7 Press and hold the same button on the original remote once again, for about
3 seconds. The LCD on the CR9000 will flash GOOD, the Device Mode and
then return to LEARN, verifying that the new function has been learned.
E a c h
14