Table of Contents
Advertisement
Advanced Features
Programming Memory Buttons:
1
Select the mode that you wish to program the Memory Button in by pressing
the corresponding Device Button (TV, VCR, CBL, SAT, or AUD) and
MUTE button, simultaneously. SET will appear in the LCD.
2
Press one of the Memory Buttons (M1, M2, M3, M4, or POWER) into
which you wish to store the functions. M(1-5)_# # will appear in the LCD.
3
Press in up to ten commands that you want stored in that Memory button.
Each successive button selection will appear as M(1-5)__(01-10) in the
LCD.
You can select functions from another mode by first pressing the
corresponding Device Button and then the buttons where those functions
are located within that mode. The selection of a Device Button also counts
as one command.
Note: Each insertion of a Device Button adds a ½ second delay to the
command sequence.
4
Press the CHANNEL Up button to store your selections. SAVE will flash
three times in the LCD to confirm the programming.
Note: It can take up to 10 seconds to send out 10 commands from a
memory button. Please continue to point the remote control at the
device(s) until all the commands on the Memory Button have been
sent out. This will ensure that all the commands are received by the
device(s).
Example: Memory Button Programming. To program Memory Button
M2 in the Audio mode to send the following commands: turn on the
Audio receiver, turn on the TV, turn on a VCR, and turn on a satellite
receiver.
29
Advanced Features
1
Press the Audio Device Button and the MUTE button, simultaneously. SET
will appear in the LCD.
2
Press Memory Button M2. M2_ # # will appear in the LCD.
3
Press the MUTE button (to turn on the Audio receiver)
M2__01 will appear in the LCD,
Press the TV Device Button (to change to the TV mode)
M2__02 will appear in the LCD.
Press the MUTE button (to turn on the TV)
M2__03 will appear in the LCD.
Press the VCR Device Button (to change to the VCR mode)
M2__04 will appear in the LCD.
Press the MUTE button (to turn on the VCR)
M2__05 will appear in the LCD.
Press the SAT Device Button (to change to SAT mode)
M2__06 will appear in the LCD.
Press the MUTE button (to turn on the Satellite receiver)
M2__07 will appear in the LCD.
4
Press the CHANNEL UP button. SAVE will flash in the LCD, and the
remote will return to the AUDIO mode.
Erasing Memory Buttons
1
Select the mode in which you want to erase the Memory Button.
2
Press the corresponding Device Button and MUTE button, simultaneously.
Press the Memory Button to be erased. M(1-5)_# # will appear in the LCD.
3
Press the Channel Up button. Save will flash in the LCD. The Memory
Button is now erased.
Note: Any previously stored commands on a Memory Button will be
erased when new commands are stored on the same Memory Button.
30
Advertisement
Table of Contents
