Recalling The Set Up Code Number - Arcam CR 9000 Operating Manual

Using Your Remote
If you pass the correct Set-Up Code number, you can return to it by
pressing the CHANNEL DOWN button, one Set-Up Code number at a
time, until your device turns back on.
Note: During programming, the signal for POWER ON and POWER OFF is located on
the MUTE button. For devices that use separate POWER ON and POWER OFF buttons,
pressing the MUTE button on the remote control during programming will only turn the
device OFF.
4 Once the correct code is confirmed, press the Device Button to store the Set-Up
Code number. PASS will appear in the LCD.
5 Test the remote control for your device. Try the POWER, CHANNEL Up and
Down, VOLUME Up and Down buttons, etc. If any of the buttons do not perform
as they should, please repeat the set-up from Step 1 using the next Set-Up Code
number for your device.
Note: Some audio/video devices have separate buttons for POWER ON and
POWER OFF. To operate these devices on the remote, press the
corresponding device button to turn the equipment ON and press the
POWER button to turn the
equipment OFF.
6 Please repeat the above steps to program the remote control for each of your other
devices.
11
Using Your Remote
Recalling the Set-Up Code Number
To display the three digit Set-Up Code number that was stored for a device.
1 Press the Device Button and MUTE button, simultaneously. SET will
appear in the LCD.
2 Press the T/V button. The LCD will quickly flash the three digit Set-Up
Code number that was stored for your device in that mode.
3 Please write your Set-Up Code numbers in the chart below, for future
reference.
Set-Up Code Numbers:
AUDIO
SAT
TV
VCR
CABLE
CD
DVD
AUX
12