Kit-Lock KL1000 Installation Instructions page 2

SPECIAL NOTES
Please read carefully:
• Before installing the lock, load the
batteries and familiarise yourself with
the operation and programming.
• The handle will not turn until you
enter the factory default Master Code
11 33 55 77 or the User Code 22 44.
• Please see programming guide to set
your own codes.
• Your KitLock is supplied ready to
fit to doors up to 19mm ( 3 / ") thick.
4
For doors between 19mm ( 3 / ")
4
and 25mm (1") thick, you will need
to install the 28.5mm (1 1 / ") spare
8
spindle (see below). A 12mm ( 1 /
spindle is also included for sheet
metal doors (see below).
1. Remove the lower 2 fixing
screws.
2. Remove cover plate, spindle
and threaded shaft.
3. Replace with spare spindle
and threaded shaft.
4. Replace cover plate.
FITTING INSTRUCTIONS
The KitLock can be fitted to:
A Cabinets, cupboards and lockers
etc as a direct replacement for
existing cam locks.
1
KitLock
2
Upper fixing bolt x 2
3
Packer pieces x 3
4
Locking nut
5
Cams x 2
")
2
6
Cam fixing bolt
Batteries – 2 x 1.5V AAA
Template x 1
B It can also be fitted easily to
cupboards and cabinets that do not
have an existing locking device.
Please see installation guide on reverse
OPEN