SPECIAL NOTES
Please read carefully:
• Before installing the lock, familiarise yourself with the installation and operating instructions.
• The factory preset combination is 0-0-0-0.
• Your KitLock is supplied ready to fit to doors up to 22mm (
• Please refer to the dimensions on the reverse to select the correct back plate for the door thickness.
INSTALLATION GUIDE
The KL20 is designed to be fitted flush into a 27mm x 83mm (1
replace an existing mechanical cam lock.
Contents Default Supply
1
KitLock
2
Back Plate A with 4 x screws
3
Back Plate B with 4 x screws
1.
2.
A
A
Installing your KitLock
N.B. Optional Fixing Pack (above) may be required.
Step 1 If necessary, remove existing cam lock.
Step 2 M ark a position at a suitable distance from the door
edge, ensuring enough clearance for the cam to work.
Step 3 Mark a rectangular guide 27mm x 83mm (1
3
/
") to suit the chosen orientation.
1
4
Step 4 Drill inside the four corners, then using a hacksaw
or jigsaw, cut from the hole to hole to create the
rectangle.
KL2O
Installation and Operating Instructions
4
Straight Cam x 1
5
Cam Fixing Screw x 1
3.
B
4.
5.
/
" x
1
16
7
/
") thick.
8
/
" x 3
/
") hole, either for a new install, or to
1
1
16
4
Optional Fixing Pack
1
Back Plate C with 4 x screws
2
Straight Cam x 1
Cranked Cam x 2
3
1.
C
Step 5 Hold the lock in place and secure with the correct
back plate for the door thickness, using the 4 fixing
screws supplied.
Step 6 Fit cam and secure with cam fixing screw.
Step 7 Now check the operation of the lock using the
factory preset combination 0-0-0-0.
Step 8 Change the code using the instructions overleaf.
2.
3.