Table of Contents
Advertisement
Security Escort Point Tracking Transmitter
Radio Frequency
304 MHz (default setting)
303.825 MHz
Tab. 4.1: Radio frequency (RF) settings on dip switch
4.3
Enable/disable the auto-track
Enable or disable the auto-track feature by setting switch number 2 on the dip switch. Set
switch number 2 to the OFF position to disable the auto-track feature. Set switch number 2 to
the ON position to enable the auto-track feature. Once enabled, an alarm will trigger the
transmitter to send a signal back to the Central Console every 7 seconds for a period of 15
minutes.
Auto-track Feature (7 seconds)
Disable (default setting)
Enable
Tab. 4.2: Auto-track setting on dip switch
4.4
Enable/disable the displacement detection
Enable or disable the displacement detection feature by setting switch number 3 on the dip
switch. Set switch number 3 to the OFF position to disable the displacement detection
feature. Set switch number 3 on the dip switch to the ON position to enable the displacement
detection feature. Once enabled, any movements of the transmitter will send a signal back to
the Central Console.
Displacement Detection Feature
Disable (default setting)
Enable
Tab. 4.3: Displacement detection setting on dip switch
4.5
Enable/disable the reed switch
Enable or disable the reed switch feature by setting switch number 4 on the dip switch. Set
switch number 4 to the OFF position to disable the reed switch feature. Set switch number 4
to the ON position to enable the reed switch feature. Once enabled, the transmitter would be
able to detect the state of the attached electromagnetic circuitry.
Reed Switch Feature
Disable (default setting)
Enable
Tab. 4.4: Reed switch setting on dip switch
Robert Bosch (SEA) Pte Ltd
Installation Manual
Enabling and Disabling Features | en
Switch Number on Dip Switch
1
OFF
ON
Switch Number on Dip Switch
2
OFF
ON
Switch Number on Dip Switch
3
OFF
ON
Switch Number on Dip Switch
4
OFF
ON
2018.01 | SE3v1.0 | DL
15
Advertisement
Table of Contents
