10
en | Installation and Setup
3.1.2
Mounting without the mounting plate
1.
2.
Figure 3.5: Lift printed circuit board
3.
4.
Figure 3.6: Mount point transmitter in desired position
3.1.3
Mounting the magnet
Mount the magnet as shown in the following figure. The magnet must mount within 19 mm
(0.75 in.) of the base of the unit.
2018.01 | SE3v1.0 | DL
If the battery was installed in the point transmitter, remove it at this time.
Using a small screwdriver, gently lift the printed circuit board away from the case
mounting clips. You do not need to remove the cover to remove the board.
Rock the board gently to loosen the battery clips from the case and slide the board away
from the mounting clips near the area where the cover connects to the base.
Mount the point transmitter in the desired location, taking note the magnet needs to be
on the same side of the case as the reed switch.
1 Magnet side
2 Mounting holes
Installation Manual
Security Escort Point Tracking Transmitter
Robert Bosch (SEA) Pte Ltd