Security Escort Point Tracking Transmitter
Figure 3.7: Mount the magnet
3.2
Powering up the point transmitter
The SEC-3402 series can be powered up either by 3V battery or 12 VDC input, depending on
the setting of the jumper.
3.2.1
3V battery
1.
2.
Figure 3.8: Install battery
Robert Bosch (SEA) Pte Ltd
1 End view from the opening end
Check that the jumper is set over the jumper pins marked by the
default factory setting on the point transmitter.
Install the recommended type of battery: Duracell® DL123A, Energizer® EL123AP or
Panasonic® CR123A. Be sure to observe the polarity.
1 Jumper setting
2 Battery
Installation Manual
Installation and Setup | en
symbol. This is the
2018.01 | SE3v1.0 | DL
11