Security Escort Personnel Transmitter
6
Basic Transmitter Features
This section provides information of the various features of the transmitter.
6.1
Features for Transmitter Profiles
The table below lists the various transmitter profiles and their features:
Features
Man-down
Supervision Tracking (Silent)
Auto-tracking
Lanyard Snatch Alarm
Lanyard Snatch Alarm (Silent)
Manual Alarm
Manual Alarm (Silent)
By default, all features emit a series of mixed tones unless otherwise stated as silent.
6.2
Transmitting a Manual Alarm
Initiate an alarm by pressing and holding the Alarm button for 1 second.
This emits a series of mixed tones for 2 seconds and sends an alarm signal to the Central
Console. If alarm is activated within sight of a receiver, the red LED on the receiver lights up.
After initiating a manual alarm, the Auto-tracking feature sends your latest location to the
Central Console every 7 seconds.
Reset the transmitter after a manual alarm by performing a test mode as described in Testing
the Transmitter, page 14.
6.3
Man-down Alarm
Whenever you are in a prone position (60° from upright), the transmitter sends an alarm
signal.
If alarm is activated within sight of a receiver, the red LED lights up.
Reset the transmitter after a Man-down Alarm by returning the transmitter to the upright
position and performing a test mode.
6.4
Lanyard Snatch Alarm
Initiate an alarm by pulling the lanyard off the transmitter.
This emits a series of mixed tones for 2 seconds, followed by short beeps at 250 millisecond
intervals. The transmitter sends an alarm signal to the Central Console. If activated within
sight of a receiver, the red LED of the receiver lights up.
To reset the transmitter after a Lanyard Snatch Alarm, reinsert the lanyard pin and perform a
test mode.
6.5
Auto-tracking
The Auto-tracking feature sends the latest location to the Central Console every 7 seconds
after an alarm is triggered.
Robert Bosch (SEA) Pte Ltd
Transmitter Profiles
User
Installation Manual
Basic Transmitter Features | en
Maintenance
Security
2017.11 | SE3v1.0 | DL
15