Bosch SEC-3402 Series Quick Installation Manual

1 |
FCC/IC Information
This device complies with Part 15 FCC Rules
and Industry Canada's license-exempt RSSs. Op-
eration is subject to these conditions: (1) this
device may not cause harmful interference, and
(2) this device must accept any interference re-
ceived including interference that may cause un-
desired operation.
Notice!
For the full FCC/IC information, refer to
the Security Escort Point Tracking Trans-
mitter Installation Manual, downloadable
from http://www.boschsecurity.com.
Installation and Setup
This section provides information for system
planners and configurators.
5 |
2. Using a small screwdriver, gently lift the
printed circuit board away from the case
mounting clips. You do not need to remove
the cover to remove the board.
Fig. 5: Lift printed circuit board
3. Rock the board gently to loosen the battery
clips from the case and slide the board away
from the mounting clips near the area where
the cover connects to the base.
4. Mount the point transmitter in the desired
location, taking note the magnet needs to be
on the same side of the case as the reed
switch.
2 |
Mounting the point transmitter
Notice!
Avoid mounting the point transmitter
on metal surfaces as it can reduce the
range of the unit.
Recommended mounting
1. Position the mounting plate over the desired
location and attach it with the supplied
screws.
Fig. 1: Attach mounting plate
1 Release tab 2 Mounting holes
2. Open the cover using a screwdriver.
6 |
Fig. 6: Mount point transmitter in desired
position
1 Magnet side 2 Mounting holes
Mounting the magnet
Mount the magnet as shown in the following fig-
ure. The magnet must mount within 19 mm
(0.75 in.) of the base of the unit.
3 |
Fig. 2: Open cover
1 Insert screwdriver 2 Push in
and press here
3. Be sure to note the location of the magnet
when mounting the base.
4. Slide the point transmitter over the base to
lock it into place.
Fig. 3: Slide point transmitter over base
7 |
Fig. 7: Mount the magnet
1 End view from the opening end
Powering up the point transmitter
The SEC-3402 series can be powered up either
by 3V battery or 12 VDC input, depending on the
setting of the jumper.
3V battery
1. Check that the jumper is set over the jumper
pins marked by the symbol. This is the
default factory setting on the point transmit-
ter.
4 |
5. The point transmitter can be released from
the base by pressing the release tab with a
small screwdriver or a paper clip.
6. For higher security installations, mount the
transmitter using the tamper screw
provided.
Fig. 4: Mount transmitter using tamper
screw
1 Tamper screw
Mounting without the mounting plate
1. If the battery was installed in the point trans-
mitter, remove it at this time.
8 |
2. Install the recommended type of battery:
Duracell® DL123A, Energizer® EL123AP or
Panasonic® CR123A. Be sure to observe the
polarity.
Fig. 8: Install battery
1 Jumper setting 2 Battery
12 VDC input
1. Set the jumper over the jumper pins as illus-
trated in the diagram below.
2. Connect the 12 VDC source to the connector
of the transmitter.