TP-Link EAP120 Quick Installation Manual page 2

Option 1: Ceiling Rail Mounting
Ceiling T-rail Clip M3×6 Pan-head Screws
(Qty.5)
1
Position the Ceiling T-rail Clip and push the movable
part toward the rail base.
2
Use an M3×6 pan-head screw to secure the T-rail Clip
onto the ceiling rail.
3
Attach the mounting bracket to the Ceiling T-rail Clip
using four M3x6 pan-head screws.
4
Attach the EAP to the mounting bracket by aligning
ARROW 1 (on the EAP) with ARROW 2 (on the
mounting bracket), then rotate the EAP clockwise until
it locks into place.
5
Connect the Ethernet cable to the ETHERNET port.
Website: http://www.tp-link.com Tel: +86 755 26504400
Option 2: Ceiling Mounting
Hole for Ethernet cable
E-mail: support@tp-link.com
Washers M3×30 Pan-head Screws Wing Nuts
(Qty.3) (Qty.3)
(Qty.3)
1
Remove the ceiling tile.
X3
2
Place the mounting bracket in the center of the ceiling
tile. Mark the three positions of the screw holes and a
10mm hole for the Ethernet cable to feed through.
Drill three 4mm holes and a 10mm hole for the Ethernet
cable.
3
Secure the mounting bracket to the ceiling tile using
three M3x30 pan-head screws, washers and wing
nuts, as shown on the left.
4
Attach the EAP to the mounting bracket by aligning
ARROW 1 (on the EAP) with ARROW 2 (on the
mounting bracket), then rotate the EAP clockwise until
it locks into place.
5
Feed the Ethernet cable through the hole and set the
ceiling tile back into place. Connect the Ethernet
cable to the ETHERNET port.
Option 3: Wall Mounting
M3×28 Plastic Wall Anchors M3×20 Self-tapping Screws
(Qty.3) (Qty.3)
1
Attach the EAP to the mounting bracket by aligning
ARROW 1 (on the EAP) with ARROW 2 (on the
mounting bracket), then rotate the EAP clockwise until
it locks into place.
2
98.6mm
Make two small pencil marks on the wall. Make sure
the two marks are level and should be 98.6mm apart.
Drill two 6mm holes through the center of your marks.
3
Insert the plastic wall anchors into the 6mm holes and
drive the self-tapping screws into the anchors. Do not
drive the screws all the way in and leave enough
clearance to hang the EAP.
4
Hang the EAP on the screws. Make sure the EAP is
firmly seated against the wall.
5
Connect the Ethernet cable to the ETHERNET port on
the EAP.
Copyright © 2015 TP-LINK