Ringdale ISDN Router ISDN User Manual page 41

CONFIGURING YOUR ROUTER
To setup any type of routing, you must first enable one of the
options below.
Note: The protocol options setup here must be the same protocol
options setup for the device being called. If, for instance, the
device being called is setup for IP Routing but not IPX Routing or
Bridging, then the selected router must also be setup for the same
options. If not, then when a call is placed, the call will disconnect
during PPP negotiations.
Enable IP Routing: Select this option to allow the selected router
to route TCP/IP packets.
Enable IPX Routing: Select this option to allow the selected
router to route IPX packets.
Enable Bridging: Select this option to allow the selected router to
act as a bridge between two physical networks (the actual cables or
hubs which form a network).
41