Task 7 Configuring Bridging - Ringdale ISDN Router ISDN User Manual

Task 7: Configuring BRIDGING
From the Setup Menu,
Press 6
to configure Bridging.
The prompt
BRIDGING
will appear at the bottom of the video display.
The default of BRIDGING is Disabled.
Pressing the spacebar switches between Disabled and Enabled.
Choices:
• Enabled allows you to use your router as a bridge
between two physical Ethernet networks.
• Disabled does not allow your router to act as a bridge
between two physical Ethernet networks.
Press the Enter key when you are ready to continue.
If you chose Enabled for BRIDGING, then the following
additional prompts will appear:
These prompts should only concern you if your Ethernet network uses
Ethernet II frames.
Press the spacebar for each of the following choices in order to switch
between Disabled and Enabled.
CONFIGURING WITH A LOCAL CONSOLE
: Disabled
145