Toshiba e-Studio2505AC Hardware Troubleshooting Manual page 60

1.TROUBLESHOOTING FOR THE HARDWARE
10 Confirm that the paper size is correctly detected if you selected [Auto (mm)] or [Auto (inch)] in
step 8.
The detected paper size is indicated on the drawer button in the equipment status indication area on the left.
An incorrect paper size or "
 P.9 "When This Screen Is Displayed"
Try copying or printing again.
11
 Misfeed when making copies or prints (using the bypass tray)
Clear the paper misfeed following the guidance shown on the touch panel. Then close all the
1
covers.
Press [Yes] when "Cancel print job?" appears.
2
The print job is canceled.
If you do not want to cancel the print job
To restart the job without canceling it, replace the paper on the bypass tray with that corresponding to the size
set in the equipment after the paper misfeed is cleared. Then if you press [No] in step 2, the job can be restarted.
In this case, it is not necessary to follow step 3 and later.
Place the paper on the bypass tray and set the paper size.
3
4 Try copying or printing again.
60 Clearing a Paper Misfeed
" indicates an unsuccessful detection. In this case, see the following page.