Toshiba e-Studio2505AC Hardware Troubleshooting Manual page 14

1.TROUBLESHOOTING FOR THE HARDWARE
Message
Cannot print this paper size
Select the other drawer.
Cannot print this paper type
Set the other paper type
Change from this mode
Count over, cannot store
anymore
Ready(*** Toner Not
Recognized)
Check the toner cartridge
Ready (Saddle Stitch Tray Full)
Ready (Check Saddle Stitch
Stapler)
Ready (Check Saddle Stitch
Stapler)
Ready (Check Stapler)
Ready (Check Stapler)
Ready (Hole Punch Dust Bin is
Full)
Ready (Finisher Full)
Ready (Inner Tray Full)
14 Messages Displayed on the Touch Panel
Problem Description
Printing was attempted but
failed. The paper could not be
output on the tray selected for
the paper output because of a
mismatch between the paper
size and the tray.
Printing was attempted but
failed.
The paper could not be output
in the tray selected because of a
mismatch between the paper
type and the tray.
(Special paper, thick 4 paper or
thin paper tried to be output on
the lower receiving tray of
MJ-1109/MJ-1110.)
The number of originals to be
scanned has exceeded the limit
specified with the department
or user code during scanning.
The toner cartridge indicated by
*** is not installed at all or
improperly so.
The terminal of the toner
cartridge is stained.
The recommended toner
cartridge is not being used.
The saddle stitch tray of the
finisher is full of paper.
A staple jam has occurred in the
stapler of the saddle stitch unit
or the staple sheet has not been
fed sufficiently.
Staples in the stapler of the
saddle stitch unit have almost
run out or have actually done
so.
Staple jam has occurred in the
stapler of the finisher.
Staples in the stapler of the
finisher have almost run out or
have actually done so.
Hole punch dust bin is full of
paper punchings.
The receiving tray of the finisher
is full of paper.
The exit tray of the equipment is
full of paper.
Corrective Action
Delete the failed print job, select the
appropriate tray for the paper, and perform
printing again.
For the restrictions of the paper type and the
receiving trays, refer to the Quick Start Guide.
Delete the failed print job, select the
appropriate tray for the paper, and perform
printing again.
Ask your administrator for details of setting
the limit for the number of copies.
Install the toner cartridge correctly.
 P.70 "Replacing a Toner Cartridge"
Wipe the terminal with a soft cloth.
Use the recommended toner cartridge.
 P.70 "Replacing a Toner Cartridge"
Remove the paper from the saddle stitch tray
of the finisher.
Remove the top staple sheet.
 P.68 "Saddle Stitch unit"
Replace the staple case of the saddle stitch
unit if stapling is not performed for an output
document even though the stapling function
has been selected.
 P.82 "Saddle Stitch unit"
Remove the jammed staples.
 P.63 "Clearing a Staple Jam"
Replace the staple case of the finisher if
stapling is not performed for an output
document even though the stapling function
has been selected.
 P.79 "Refilling With Staples"
Remove the paper punchings.
 P.93 "Cleaning the Hole Punch Dust Bin"
Remove the paper from the receiving tray of
the finisher.
Remove the paper from the exit tray of the
equipment.