Genie Z-30/20N Service Manual page 43

April 2005
REV B
16 Install a new bearing grease seal into the hub
by pressing it evenly into the hub until it is flush.
17 Slide the hub onto the yoke spindle.
Component damage hazard. Do
not apply excessive force or
damage to the lip of the seal may
occur.
18 Place the outer bearing into the hub.
19 Install the washer and castle nut.
20 Tighten the castle nut to 35 ft-lbs / 47 Nm to
seat the bearings.
21 Loosen the castle nut and re-tighten to
8 ft-lbs / 11 Nm.
22 Install a new cotter pin. Bend the cotter pin
to lock it in.
Always use a new cotter pin when
installing a castle nut.
23 Install the dust cap, then the tire and wheel
assembly. Torque the wheel lug nuts to
specification. Refer to Section 2, Specifications.
24 Raise the machine and remove the blocks.
Lower the machine to the ground.
Part No. 106373
Section 3 • Scheduled Maintenance Procedures
Genie Z-30/20N
CHECKLIST E PROCEDURES
3 - 29