Advertisement
Environment
WARNING
To prevent injury or death, do not use near explosive gas or vapor.
CAUTION
To prevent damage to the probe, do not use in wet or damp conditions
and always use and store your probe in appropriate environments.
Temperature
Max. humidity
(non-condensing)
Max. altitude
Pollution degree
Care of the product
The probe contains no user-serviceable parts. Repair, servicing and
calibration require specialized test equipment and must only be performed
by Pico or an approved service provider. There may be a charge for these
services unless covered by the Pico two-year warranty.
WARNING
To prevent injury or death, do not use the product if it appears to be
damaged in any way, and stop use immediately if you are concerned
by any abnormal behavior.
CAUTION
To prevent damage when cleaning the exterior of the probe, use a soft
cloth moistened with either distilled water or isopropyl alcohol. Before
use allow the probe to dry completely. Do not allow liquids to enter the
probe casings and ensure that the probe is completely dry before use.
Take care to avoid mechanical stress or tight bends on the
coaxial cable connecting the probe head to its interface box or
BNC connector. Mishandling could degrade performance and
measurement accuracy. Avoid mechanical shock to the probe in
general to guarantee accurate performance and protection.
To avoid injury from the sharp tip, handle with care.
Storage
–20 °C to +60 °C
0 % to 90 %RH
15 000 m
2 (As defined in IEC 61010-031. Non-conductive
pollution with occasional temporary conductivity due to
0 °C to +50 °C
0 % to 80 %RH
condensation.)
Operating
2000 m
Advertisement
