Sabo 97-14 HS Operator's Manual page 41

2. Connect positive (+) charger cable to positive (+) battery
terminal.
3. Connect negative (-) charger cable to negative (-)
battery terminal.
4. Plug in charger cord.
5. Charge battery using a 12 Volt battery charger at a rate
of 6-10 amperes for a minimum of 1 hour and no more than
2 hours.
6. Unplug charger cord. Remove charger cables.
7. Install battery. (See Removing and Installing Battery in
this section.)
Using Booster Battery
c
CAUTION: Avoid injury! The battery produces a
flammable and explosive gas. The battery may
explode:
• DO NOT attempt to jump start if the dead
battery is frozen.
• DO NOT smoke.
• Wear eye protection and gloves.
• Keep all flames and sparks away.
• DO NOT connect the negative (-) booster
cable to the negative (-) terminal of the
discharged battery. Connect at a good ground
location away from the discharged battery.
SERVICE ELECTRICAL
1. Connect positive (+) booster cable to booster battery (A)
positive (+) post (B).
2. Connect the other end of positive (+) booster cable to
vehicle battery (C) positive (+) post (D).
3. Connect negative (-) booster cable to booster battery
negative (-) post (E).
4. Connect the other end (F) of negative (-) booster cable
to a metal part of the machine frame away from battery.
5. Start the engine of the disabled machine and run
machine for several minutes.
6. Carefully disconnect the booster cables in the exact
reverse order: negative cable first and then the positive
cable.
Replacing Headlight Bulb
1. Lift hood.
2. Push in and turn bulb socket (A) 1/4 turn
counterclockwise to remove.
3. Replace defective bulb with a new bulb.
4. Insert bulb socket into housing, push in and turn 1/4 turn
clockwise to install.
5. Lower hood.
Service Electrical - 37
F
D
E
C
A
B
A
M88559