Troubleshooting; Led Indicators - Honeywell S9200U1000 Installation Instructions Manual

TROUBLESHOOTING

WARNING
Fire, Explosion, or Electrical Shock Hazard.
Can cause severe injury, property damage, or death.
Do not attempt to modify the physical or electrical
characteristics of this device in any way. Replace
it if troubleshooting indicates a malfunction.
IMPORTANT
1. The status codes outlined in Table 11, Table 12,
and Table 13 beginning on page 20 are a gen-
eral guide. Follow appliance manufacturer ser-
vice instructions when available.
2. Take all meter readings within the Trial for Igni-
tion period. After the ignition period ends, before
continuing, reset the system by turning down the
thermostat for at least five seconds but for less
than 20 seconds.
3. If any component does not function properly,
make sure it is correctly installed and wired
before replacing it.
4. Static discharge can damage the integrated fur-
nace control. Touch an appliance metal surface
to discharge static electricity before touching the
furnace control.
5. The S9200U1000 cannot be repaired. If it mal-
functions, replace it.
6. Only trained, experienced service technicians
should service integrated furnace control systems.
Perform the checkout steps listed in "Checkout" on
page 13 before beginning any troubleshooting pro-
cedure. After troubleshooting, check out the system
again to be sure it is operating normally.
S9200U1000 UNIVERSAL HOT SURFACE IGNITION INTEGRATED FURNACE CONTROL

LED Indicators

The S9200U1000 has three LEDs. The three LEDs from
left to right as shown in Fig. 4 on page 9 are:
• Flame – Amber LED
The Amber LED Indicates flame status such as weak
or no flame. The Flame status codes are mapped in
Table 11 on page 20.
• STATUS – Red LED
The Red LED indicates general system status, such as
the presence of a call for heat and various error codes.
The Status LED Status codes are mapped in Table 12
on page 20.
• E-COM – Green LED
This Green LED indicates EnviraCOM™ transmission
is underway. The LED is directly linked to communica-
tion on the EnviraCOM™ bus. The E-COM LED Status
codes are mapped in Table 13 on page 21.
— A typical transmitted message appears as a rapid
flashing of the green LED.
— A typical received message appears as single
blink, indicating the S9200U1000 has acknowl-
edged the message.
NOTE: The E-COM LED is active even if a conventional
thermostat is controlling the appliance.
Flash Code Descriptions
The LEDs flash codes at various intervals. Each pulse
type indicates a specific functionality/ message type.
• Periodic Blink (Normal): 0.5 second on, 0.5 second
off.
• Pulse: A 0.25 second flash followed by 3.75 seconds
of off time.
• Heartbeat: Constant 0.5 second bright, 0.5 second
dim cycles.
• Standard LED Fault Pattern (Single X Flash): LED
flashes X times at 2HZ, then off for 3 seconds.
• Advanced LED Fault Pattern (X + Y Flash):
LED flashes X times at 2Hz, remains off for one
second, flashes Y times at 2Hz, remains off for three
seconds, and then repeats.
19 69-2075EF—01