Snow Performance 20010 Installation Instructions Manual page 7

Warranty
Snow Performance's commitment to providing the best
water/methanol systems is reflected in the components and
construction of all Snow Performance Boost Cooler® kits.
A lifetime warranty for injection systems is available with
exclusive use of Boost Juice™ injection fluid. The standard
warranty is 2-years from purchase and covers all Snow
Performance products and accessories purchased on or after June
1, 2009 manufactured by Snow Performance, Inc. (Snow). This
warranty terminates when the original retail purchaser sells or
otherwise transfers the product to any other person.
Warranty Policy
Snow Performance, Inc. warrants that the Product shall conform to
and perform in accordance with published technical specifications
and shall be free of defects in materials and workmanship
providing:
1. You are the original purchaser and provide proof of purchase.
2. For lifetime warranty, the Warranty Card that came with system
(not applicable to separate parts purchases) is returned to Snow
within 90-days of purchase. If valid warranty card not on file with
Snow, the standard 2-year warranty applies from date of purchase.
3. An RMA # has been attained and is displayed on package
containing returned part.
Subject to Snow's inspection of the product, Snow will remedy
defects in materials and/or workmanship by repairing or replacing,
at Snow's option, the defective product without charge for parts or
labor, subject to the limitations and exclusions described in this
warranty.
© 2009, Snow Performance, Inc
Step 3 Nozzle Selection
Nozzle sizing is a function of horsepower, which approximates the
engine airflow, and boost, which approximates intake charge heat.
Recommended starting points:
250 - 350 RWHP:
350 - 475 RWHP:
475 - 600 RWHP
Seal the nozzle into the nozzle holder using the
included E6000® sealant. Using a sealant that is
not permanent will allow for nozzle changes during tuning. Simply
remove the nozzle, clean the threads, and reinstall using sealant.
Assemble desired nozzle into nozzle holder using E6000® sealant. The
end of the nozzle with the fine mesh screen is to be inserted into
the nozzle holder. Torque ½ turn past finger tight. Do not use Teflon
sealants on Snow Performance fittings.
Correct
NOTE: If nozzle is mounted lower then the reservoir, a Solenoid Upgrade
(#40060) must be used to prevent draining.
© 2009, Snow Performance, Inc
175 ml/min nozzle.
375 ml/min nozzle
625 ml/min nozzle
Incorrect