Snow Performance 20010 Installation Instructions Manual page 6

Step 2 Pump Install
Mount the pump so the inlet is positioned at the lowest point of the
reservoir or lower. Pump can be mounted horizontally or vertically using
the supplied screws and washers. Ensure that no sharp bends in the
high pressure tube occur near the pump. Sharp bends can cause stress
on the inlet and outlet ports of the pump, causing leaks. Trim tube with a
utility knife or razor blade, making sure to eliminate any burrs or kinks on
the end. Insert firmly into the pump about ½ inch through the light grey
locking collar. Note the arrows indicating flow direction on the top of the
pump. To remove the hose, gently and evenly push the light grey locking
collar into the head unit of the pump, then pull on the hose gently.
Mount pump away from direct road spray and
debris.
Measure the distance from the reservoir outlet to the pump inlet. Cut the
¼" red tubing using utility knife. Make cuts are as square as possible.
Ensure there are no kinks in the tubing and insert tubing into quick
disconnects at pump and reservoir until fully seated. Keep the pump
within 2 feet of the reservoir.
© 2009, Snow Performance, Inc
This warranty does not cover problems caused by normal wear and
tear including aesthetic oxidation of surfaces, accidents, unlawful
vehicle operation, or modifications or repairs to product not
performed or authorized by Snow. This includes any product that
is disassembled or taken apart for any reason.
In addition, this warranty does not cover problems resulting from
conditions beyond Snow's control including, but not limited to,
theft, misuse, overloading, or failure to assemble, mount or use the
product in accordance with Snow's written instructions or
guidelines included with the product or made available to the
original retail purchaser.
In the event of failure, Snow will repair or replace the part at
Snow's sole discretion. Failures resulting from misapplication or
misuse of the Product, failure to adhere to any specifications or
instructions, or failure resulting from neglect, abuse, accidents, or
act of nature are not covered under this warranty.
Warranty service may be obtained by calling 866-365-2762,
getting an RMA (Return Merchandise Authorization), delivering
the part to Snow along with proof of purchase. Customer agrees to
insure the Product or assume the risk of loss or damage in transit,
to prepay shipping charges to Snow, and to use the original
shipping container or equivalent. Shipping for Warranty
replacement parts shipped outside the continental US will be
charged to customer.
© 2009, Snow Performance, Inc