Delete Fingerprints; Toggle Bluetooth - Vaultek PROMXI Instruction Manual

Save battery life by disabling the proximity sensor, fingerprint sensor, keypad, status
bar, and Bluetooth features. To toggle travel mode ON/OFF press and hold keys '1'
and '8' together for 3 seconds. The screen will indicate ENABLED or DISABLED.
To check the battery level press and hold keys '6' and '8' together for 3 seconds. The
screen will indicate the battery level. See pages 07 to 09 for more information.

Delete Fingerprints

To delete fingerprints press and hold the '3' key then "PROGRAM" button together
until the safe beeps and the screen prompts you to enter your master code. Enter
Press and hold '3' then
your master code on the keypad. If the code is correct, the safe will beep and the
"PROGRAM" button then
screen will indicate deletion of all the fingerprints. This will remove all the
enter master code
fingerprints. You can delete individual fingerprints in the Vaultek™ app.
Toggle LCD The LCD screen has four brightness levels: 25%, 50%, 75%, and 100%. To toggle
the LCD brightness press and hold '5' and '8' together for 3 seconds. The screen will
Brightness
indicate the brightness level.
Press and hold '5'and '8'
19 Vaultek™

Toggle Bluetooth

To toggle the Bluetooth ON/OFF press and hold the '4' key then "PROGRAM"
button together for 3 seconds. The screen will indicate ENABLED or DISABLED.
Press and hold '4' then
If Bluetooth is toggled OFF all app functions will be disabled and your safe is
"PROGRAM" button
undiscoverable.
Toggle Smart Key
The Smart Key has THREE modes: OFF, Progressive Entry Mode, and On Demand
Entry Mode. OFF disables Smart Key access. Progressive Entry Mode requires that
Modes
Press and hold '6'
you press one key on the safe keypad first and then activate the Smart Key. On
then "PROGRAM" button
Demand Entry Mode grants immediate access when activating the Smart Key.
Pressing and holding the '6' key then "PROGRAM" button together for 3 seconds
will allow you to toggle through each mode from the keypad. You may also alternate
modes in the Vaultek™ app.
Toggle DMT Your Vaultek™ safe has a built-in accelerometer and corresponding alarm that
alerts of any attacking to your safe including bumps and impacts, DMT (Impact
Sensitivity
Press and
Detection). DMT is enabled by default and its sensitivity has three settings;
hold '7' then "PROGRAM"
Low, Medium, and High. You can toggle through these settings by pressing and
button
holding the '7' key then "PROGRAM" button together for 3 seconds. The screen will
indicate LOW, MEDIUM, and HIGH as well as DISABLED.
Toggle Dual
To toggle the Dual Entry ON/OFF press and hold the '8' key then "PROGRAM"
button together for 3 seconds. The screen will indicate ENABLED or DISABLED. If
Entry Mode
the Dual Entry is toggled ON, you will be required to enter your master code and
Press and hold '8' then
fingerprint (and vice versa) to open the safe. This mode requires that at least one
"PROGRAM" button
fingerprint be programmed in the safe.
20 Vaultek™