Table of Contents
Advertisement
Smart Key Operation
Your Vaultek™ safe supports quick access with the included Smart Key. Take caution when using this feature and
be responsible. Security can be compromised in the event the Smart Key is lost or stolen. Only pair the Smart
Key after thoroughly understanding the inherent risks.
IMPORTANT
Before you can pair the Smart Key to your safe connect the pre-installed
battery by removing the pull tab from the side of the Smart Key (Figure H).
Smart Key Pairing
Note: As a security measure to prevent accidental access, you must
press both sides of the key simultaneously to activate referred to as
a dual press. This dual press is required for the pairing process as well
as anytime the Smart Key is used to open the safe. Following this
procedure will pair the Smart Key to your safe.
Press and hold the '5' key then "PROGRAM" button together (3 seconds)
until the LED flashes RED and the screen indicates connecting.
Aim the key towards the safe and press both sides of the key together
(Figure I). If the safe beeps and the screen indicates complete then
the Smart Key has paired successfully; if the screen indicates failed
to pair then simply start over with step one.
Enable Smart Key: After pairing the Smart Key will be immediately active to test functionality and then turn off.
Smart Key will need to be set to either On Demand or Progressive mode. See page 16 for more information.
IMPORTANT
The Smart Key functions in close proximity to safe and has a short range of approximately 5 feet (Figure I).
15 Vaultek™
FIGURE H
5FT
FIGURE I
Continue on next page for more information about the Smart Key.
Toggle Smart Key Access Modes
After pairing you can toggle between access modes from the keypad or Bluetooth app. To toggle from the keypad
press and hold the '6' key then "PROGRAM" button together. The LCD screen will communicate as directed below.
OFF
Progressive Entry Mode
Safe goes into sleep mode and will require you to wake up the safe before using Smart Key. You can wake up the
safe by pressing any key or brushing your hand across the keypad of the safe (backlit keys will turn RED).
On Demand Entry Mode
This mode grants immediate access to your safe without having to wake it up.
Warning: On Demand Entry Mode can open a safe in another room and/or out of sight. To reduce risk of
!
an unattended open safe we recommend using Progressive Entry Mode.
On Demand Entry Mode requires significant power usage and can greatly reduce operation time. We
suggest setting the Smart Key to Progressive Entry Mode to conserve battery.
To Unpair Smart Key
NOTE: Disabling the Smart Key function from the app or keypad will NOT delete a paired key from the safe's
memory. In the event a Smart Key is lost or stolen, you can delete the lost key from the safe's memory by using a
couple different methods:
A
Press and hold '5' key then "PROGRAM" button together (3 seconds) until the LED flashes RED and the screen
indicates connecting. This is the same sequence used when initially pairing. After the screen indicates failed to
pair the safe will delete a paired Smart Key from memory.
B
Anytime a new Smart Key is paired with the safe, the previous key will be erased from the safe's memory.
16 Vaultek™
Advertisement
Table of Contents
