Vaultek PROMXI Instruction Manual page 9

authorized users have access to your valuables. The safe is capable of storing fingerprint data for up to 20 unique
Helpful Programming TIPS
Place the core of the fingerprint flat (Figure E+F) over
the center of the scanner in line with the side LEDs (this
allows the scanner to read where most of the fingerprint
detail is located) see (Figure E).
Adjust your finger slightly between scans for increased
accuracy.
Excessive moisture, lotions, or dirt will affect your
fingerprint and may cause inaccurate sensor reading.
If you are experiencing difficulty try different fingers.
Each finger is unique and some fingers, such as your
thumb, contain more readable information than others.
To increase success rate register the same fingerprint
multiple times.
ATTENTION! (Figure F)
Position your finger flat against the scanner to
increase the amount of readable information.
Continue on next page for more information about the fingerprint scanner.
Programming the 1st and 2nd Fingerprints
The 1st and 2nd fingerprints will be recognized as administrative fingerprints and will be used to authorize
additional users.
Open the safe. Program 1st fingerprint by pressing and
holding the '2' key then the "PROGRAM" button together
(3 seconds)(Figure G) until the screen prompts you to scan
the 1st of five scans.
Using the helpful programming tips provided on page 11
place your finger on the fingerprint scanner for the 1st of
five scans. When the safe beeps, and the screen prompts
the next scan remove your finger. If the screen indicates a
failed to complete then start over with step 1.
Place finger again over the scanner until the safe beeps
and the screen prompts the next scan and lift. You will
repeat this process until all scans (1-5) are programmed.
Close lid and test to see if the safe will open using your fingerprint. If you experience issues refer to the helpful
programming tips listed on page 11 or check our tutorials online at vaulteksafe.com under Support/Tutorials.
Repeat steps 1 through 4 to add the 2nd administrative fingerprint.
Continue on next page to program fingerprints 3-20.
G
FIGURE G