Multiple Safe Management - Vaultek PROMXI Instruction Manual

Table of Contents

Advertisement

Smart Key Operation

Multiple Safe Management

A
Multiple safes can pair with the same Smart Key but multiple Smart Keys can not pair with one safe.
B
Recommended setting when using the Smart Key is Progressive Entry Mode.
C
Additionally you can manage multiple safes through the Vaultek™ app.
CAUTION when managing multiple safes in On Demand Entry Mode there is a chance you can open all safes
within range.
Battery Replacement
The pre-installed battery will last approximately two years
before requiring replacement. When needed follow the steps
below to complete replacement.
Carefully separate the remote body with a small coin or
your hand starting near the top of the Smart Key at the
designated coin slot.
Remove old battery and install a new model CR2032
battery (Figure J).
Assemble Smart Key back together.
17 Vaultek™
FIGURE J
!
Smart Key Warnings
Take caution when using this feature and be responsible. Security can be compromised in the event the Smart
Key is lost or stolen. Only pair the Smart Key after thoroughly understanding the inherent risks.
WARNING anyone including children can access the safe via Smart Key.
ALWAYS unpair the Smart Key in the event it is lost or stolen.
WARNING On Demand Entry Mode can open a safe in another room and/or out of sight. To reduce risk of an
unattended open safe we recommend using Progressive Entry Mode.
IMPORTANT On Demand Entry Mode requires significant power usage and can greatly reduce operation time
on a single charge. We suggest keeping the safe in Progressive Entry Mode. If using On Demand Entry Mode try
keeping the safe plugged in.
To check for tampering press and hold keys '2' and '4' together for 3 seconds. The
screen will indicate TAMPERING or CLEARED. You can reset the tamper detection by
opening the safe through one of the authorized entry points.
To toggle the sound ON/OFF press and hold keys '1' and '3' together for 3 seconds.
The screen will indicate the sound is ON and beep or the screen will indicate OFF
and not beep.
18 Vaultek™

Advertisement

Table of Contents
loading

Table of Contents