Table of Contents
Advertisement
Smart Align Biometric Programming
Programming Additional Fingerprints 3-20
The first two fingerprints programmed into the safe are the administrative fingerprints. Any additional users
programmed require authorization from one of these fingerprints.
Open the safe. Program additional fingerprints by pressing and holding the '2' then "PROGRAM" button together
(3 seconds)(Figure G on page 12). The screen will prompt you to scan one of the administrative fingerprints.
Place one of the first two programmed administrative fingerprints on the scanner and remove when the safe
beeps and screen authorizes the print. You can now program a NEW fingerprint.
TIP: If the administrative print is left on the scanner too long the safe will begin to program that fingerprint into
the safe again and not the NEW fingerprint. If this happens start over with step 1.
Using the helpful programming tips provided on page 11 place the NEW finger on the scanner. When the safe
beeps and the screen prompts the next scan remove your finger.
Place finger again over the scanner until the safe beeps and the screen prompts the next scan and lift. You will
repeat this process until all scans (1-5) are programmed.
Press and hold the '3' key then the "PROGRAM" button together until the safe beeps and the screen prompts you
to enter your master code.
Enter your master code on the keypad. If the code is correct, the safe will beep and the screen will indicate
deletion of all of the fingerprints.
Advertisement
Table of Contents
