Securing Your Safe - Vaultek VT20i Instruction Manual

Securing Your Safe

Your Vaultek™ safe can be secured a few different ways. Included is a security cable to attach your safe to larger
stationary objects. There are also mounting screws included to mount the safe to a flat surface using the
pre-drilled holes on the bottom.
Using the Security Cable
Loop the security cable around a secured object.
Run the end of the cable through the eye of the other
end and pull tight around the object.
Place the stud on the loose end of the security cable
through one of the mounting holes on the back side of
the Vaultek™ safe as shown in (Figure K).
Screw the provided nut onto the stud and tighten.
Using the Mounting Screws
TIP: Make sure you have enough clearance for the lid to
open properly before mounting the safe.
Position the safe on a flat surface where you want to
mount it.
Use a pencil to mark the holes for drilling.
Drill pilot holes.
Position safe in place and install screws through safe
into pilot holes. Tighten screws.
15 Vaultek™ VT20i
IMPORTANT:
Mounting the safe vertically so that the door flips
upward will result in incomplete opening of the safe
due to weight. The door will open if the safe is
mounted vertically so that door opens down or to
the side.
FIGURE K