Reassem
1.
Install the clutch housing
(61),
capscrews (157)
A
Faceof housing
and lockwashers
(156)
on the engine. See Fig.
44.
2. Install the engine shaft key
(66). See Fig.
44.
3. Install the
clamp
(68) onto the engine shafl (A).
sion shown in Fig. 45.
Maintain the
1.99
in.
+I-
0.01
(50.55
mm) dimen-
To check the dimension, place
a
rigid, straight steel
bar (B) across the face of the dutch housing (61).
Use
an accurate measuring device to measure the
distance between the inside of the bar and the face
thetwo screws (60) to 125 in-lb (14 Nm).
of the clamp. Adjust the clamp as necessary. Torque
4. Connect the wires of the hamess
(58)
to the screws
(57)
In both places on the field. Pull the plastic caps
(C) up and snap them over the screws. Guide the
wires of the harness (58) through the slot in the
clutch housing. Slide the field
(70)
into the clutch.
Align the. setscrew chamfers in the field and
the
clutch housing
(61).
Tighten the setscrews (62) op-
positely and evenly, to
25
in-lb (2.8 N.m). See Fig.
44.
A
1.99" (50.55 mm)
A
Torque
lo 1 2 5
In-lb
(14 N.m)
A
Torque to 125
in-lb
(14
N.m)
SIDE CUTAWAY VIEW OF CLUTCH HOUSING
Fig.
45
ODbO
Fig.
44
OM8
38
308-105