Panasonic Lumix DC-TS7 Owner's Manual page 13

1. Before Use
Handling of the camera
∫
• Waterproofing is not guaranteed if the unit is subject to an impact as a result of being hit or
dropped etc. If an impact to the camera occurs, it should be inspected (subject to a fee) by
Panasonic to verify that the waterproofing is still effective.
• Using the camera in environments where splashing with hot spring water, oil or alcohol is likely
to occur may cause the water/dust resistance and impact resistance of the camera to
deteriorate.
• When the camera is splashed with detergent, soap, hot spring, bath additive, sun oil, sun
screen, chemical, etc., wipe it off immediately.
• Waterproof function of the camera is for sea water and fresh water only.
• Any malfunction caused by customer misuse, or mishandling will not be covered by the
warranty.
• Panasonic offers no compensation for any accidents caused by use of the product (including
both personal and property damage).
• The inside of this unit is not waterproof. Water leakage will cause malfunction.
• Supplied accessories such as battery pack etc. are not waterproof. (excluding hand strap)
• Card and battery are not waterproof. Do not handle with a wet hand. Also, do not insert wet
card or battery into the camera.
• Do not leave the camera for a long period of time in cold places where the temperature reaches
s10 oC (14 oF) or lower (ski resorts, places at high altitude, etc.) or hot places where the
temperature reaches 40 oC (104 oF) or higher (in particular, places exposed to strong sunlight,
inside a sun-heated automobile, near a heater, on a boat or beach, etc.). (Doing so will
deteriorate the waterproof performance)
About the [Precautions] display
∫
• [Precautions] is displayed when this unit is turned on for the first time after purchase, with the
side door completely closed.
• Please check beforehand to maintain the waterproof performance.
• The [Precautions] screen will be displayed every time the camera is turned on if you select [No]
before displaying the screen, turn off the camera while checking the screen, or press [MENU/
SET] to force close the screen.
1
Press 2 to select [Yes], and press [MENU/SET].
• The recording screen is displayed if you select [No].
2
Press 2/1 to change the screen.
2: Return to the previous screen
1: View the next screen
3
After the final screen (12/12), press [MENU/SET] to finish.
• When [MENU/SET] is pressed after the final screen (12/12), [Precautions] is not displayed
from the next time this unit is turned on.
• This can also be viewed from [Precautions] in the
[Setup]
menu.
13