Panasonic Lumix DC-TS7 Owner's Manual page 176

12. Connecting to other equipment
4
Make print settings.
[Print with Date]
[Num.of prints]
[Paper Size]
[Page Layout]
• When you want to print pictures on a paper size or a layout which is not supported by
the camera, set [Paper Size] or [Page Layout] to [{] and then set the paper size or the
layout on the printer.
(For details, refer to the operating instructions of the printer.)
• If the printer does not support date printing, the date cannot be printed on the picture.
• Depending on the printer, the date print settings of the printer may take precedence so
check if this is the case.
5
Press 3 to select [Print start] and then press [MENU/SET].
• Disconnect the USB connection cable after printing.
• Use a battery with sufficient battery power. If the remaining battery power becomes low while
the camera and the printer are connected, the alarm beeps. If this happens during printing,
stop printing at once. If not printing, disconnect the USB connection cable.
• Do not disconnect the USB connection cable while [å] (Cable disconnect prohibit icon) is
displayed.
(May not be displayed depending on the type of printer used.)
• Before inserting or removing a card, turn the camera off, and disconnect the USB connection
cable.
Not available in these cases:
• Motion pictures, 4K burst files, and pictures recorded with [Post Focus] cannot be printed.
Sets date printing.
Sets the number of pictures to be printed (up to 10 pictures).
Sets the paper size.
Sets whether or not to add borders and how many pictures to
be printed on each sheet of paper.
176