Warranty - Pro-Ject Audio Systems 2Xperience Primary Instruction Manual

Potential incorrect use and fault conditions
Pro-Ject Audio Systems turntables are manufactured to the highest standards and undergo strict
quality controls before leaving the factory. Faults that may possibly occur are not necessarily due to
material or production faults but can sometimes be caused by incorrect use or unfortunate
circumstances. Therefore the following list of common fault symptoms is included.
The platter does not turn although the unit is switched on:
•
The unit is not connected to the mains power supply.
•
No mains at the socket.
•
Drive belt is not fitted or has slipped off.
No signal through one or other channel or both channels:
•
No signal contact from the cartridge to the internal tonearm wiring or from that to the arm
lead or
from that to the phono box or between that and the amplifier. This could be due to a faulty
plug,
broken wire or solder joint or simply loose plug/socket connection.
•
Phono input not selected at amplifier.
•
Amplifier not switched on.
•
Amplifier or speakers defective or muted.
•
No connection to the loudspeakers.
Strong hum on phono input:
•
No earth connection from cartridge or arm or arm cable to amplifier, or earth loop.
Distorted or inconsistent sound from one or both channels:
•
Record player is connected to wrong input of amplifier, or MM/MC switch incorrectly set.
•
Needle or cantilever damaged.
•
Wrong r.p.m., drive belt overstretched or dirty, platter bearing without oil, dirty or damaged.
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above
information, please contact your dealer for further advice. Only if the problem cannot be solved there
the unit should be sent to the responsible distributor in your country.
Guarantee repairs will be accepted only if the unit is returned correctly packed in the original package.
Therefore we strongly recommend keeping the original packaging.
Never return a record player without making sure that it is safely disassembled and correctly packed in
the original packaging according to the diagrams on the last page of this user guide. Please remove the
following parts from the turntable and pack them separately: power supply socket (9), counterweight
(5), anti-skating weight (13) platter (4) and belt (3). Mount the cartridge protection cap. Insert the
transport lock for the tonearm (17).

Warranty

The mXnufXcturer Xccepts no responsibility for dXmXge cXused by not Xdhering to these
instructions for use Xnd/or by trXnsportXtion without the originXl pXckXging. ModificXtion or
chXnge to Xny pXrt of the product by unXuthorized persons releXses the mXnufXcturer from Xny
liXbility over Xnd Xbove the lXwful rights of the customer.
Pro-Ject Audio Systems is a Registered Trademark
of H. Lichtenegger.
This guide was produced by: Pro-Ject Audio
©
Systems Copyright 2018. All rights reserved.
8
© Pro-Ject Audio Systems · Pro-Ject 2
The information was correct at the time of going
to press. The manufacturer reserves the right to
make changes to the technical specification
without prior notice as deemed necessary to
uphold the
development.
X
perience Primary · Revision 2018.03.08
ongoing process of technical