Warranty - Pro-Ject Audio Systems 2 Xperience Primary Instructions For Use Manual

Potential incorrect use and fault conditions
Pro-Ject Audio Systems turntables are manufactured to the highest standards and undergo strict quality
controls before leaving the factory. Faults that may possibly occur are not necessarily due to material or
production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the
following list of common fault symptoms is included.
The platter does not turn although the unit is switched on:
•
The unit is not connected to the mains power supply.
•
No mains at the socket.
•
Drive belt is not fitted or has slipped off.
No signal through one or other channel or both channels:
• No signal contact from the cartridge to the internal tonearm wiring or from that to the arm lead or
from that to the phono box or between that and the amplifier. This could be due to a faulty plug,
broken wire or solder joint or simply loose plug/socket connection.
•
Phono input not selected at amplifier.
•
Amplifier not switched on.
•
Amplifier or speakers defective or muted.
•
No connection to the loudspeakers.
Strong hum on phono input:
• No earth connection from cartridge or arm or arm cable to amplifier, or earth loop.
Distorted or inconsistent sound from one or both channels:
•
Record player is connected to wrong input of amplifier, or MM/MC switch incorrectly set.
•
Needle or cantilever damaged.
•
Wrong r.p.m., drive belt overstretched or dirty, platter bearing without oil, dirty or damaged.
Service
Should you encounter a problem which you are not able to alleviate or identify despite the above information,
please contact your dealer for further advice. Only if the problem cannot be solved there the unit should be
sent to the responsible distributor in your country.
Guarantee repairs will be accepted only if the unit is returned correctly packed in the original package. Therefore
we strongly recommend keeping the original packaging.
Never return a record player without making sure that it is safely disassembled and correctly packed in the
original packaging according to the diagrams on the last page of this user guide. Please remove the following
parts from the turntable and pack them separately: power supply socket (9), counterweight (5), anti-skating
weight (13) platter (4) and belt (3). Mount the cartridge protection cap. Insert the transport lock for the
tonearm (17).

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions
for use and/or by transportation without the original packaging. Modification or change to any part
of the product by unauthorized persons releases the manufacturer from any liability over and above
the lawful rights of the customer.
Pro-Ject Audio Systems is a Registered Trademark of
H. Lichtenegger.
This guide was produced by: Pro-Ject Audio Systems
Copyright 2015. All rights reserved.
©
© Pro-Ject Audio Systems · Pro-Ject 2Xperience Primary· Revision 2020.13.07
The information was correct at the time of going to
press. The manufacturer reserves the right to make
changes to the technical specification without prior
notice as deemed necessary to uphold the ongoing
process of technical development.
7