Table of Contents
Advertisement
1 Remove the two screws on the
bottom of this product.
Note
Remove the screws with a commercially available #0
Phillips screwdriver.
2 Release the four hooks that hold
the display side of the case.
The locations of the hooks are shown in the
following diagram.
Note
The hooks can be released with a flathead screw-
driver.
3 Disconnect the display-side
connector.
4 Disconnect the speaker connector,
and remove the four screws
holding the board.
5 Lift up the board, disconnect the
connector, and remove the battery.
CAUTION
The battery is attached with double-sided tape. If the
battery is difficult to remove, insert a flathead screw-
driver in between the battery and case to remove it.
Be careful not to damage the battery when doing so.
Hide quick links:
Advertisement
Table of Contents
