Group Start/Stop Settings: Menu Par G2 - Vacon 20 SERIES Applications Manual

Description of Groups
2.2.2

Group Start/Stop Settings: Menu PAR G2

Code Parameter
AUTO
P2.1
Start/Stop logic
AUTO
P2.2
Run control
P2.3 Start function
P2.4 Stop function
P2.5 Quick Stop Function
P2.6 Manual Start mode
(*)Selection 1 is available only if ASi board is not installed. In this case a different
NOTE!
fieldbus can be used to control the drive. When ASi board is installed this param-
eter is automatically set to 0.
Service support: find your nearest Vacon service center at www.vacon.com
Min Max Unit Default
0 3 0
0 1* 1
0 1 0
0 1 0
0 1 0
0 1 1
Table 31: Group Start/Stop settings.
ID Level Description
Logic = 0:
Start sgn 1 = Start Forward
Start sgn 2 = Start Back-
ward
Logic =1:
Start sgn 1 = Start Forward
(edge)
300 Basic Start sgn 2 = Start Back-
ward (edge)
Logic = 2:
Start sgn 1 = Start
Start sgn 2 = Reverse
Logic = 3:
Start sgn 1 = Start (edge)
Start sgn 2 = Reverse
0= Start 1-Start 2 signals
125 Advanced
1= non-ASi fieldbus
0=Ramping
505 Advanced
1=Flying start
0=Coasting
506 Advanced
1=Ramping
0=Signal level
1896 Basic
1=Signal edge
0=Signal level
1899 Advanced
1=Signal edge
vacon • 16
2